KAMENG HEP [NEEPCO] (4 X 150 MW)
Unit 4 Generator Box/ |
Stator Unit 4 Lowering in Pit/ |
Stator Unit 4 Lowering in Pit/ |
Machine Hall Viewed from Service Bay/ |
Ventilation Duct Erected at Auxiliary Floor/ |
Lowering of Generator Rotor/Unit IV |
Power House /from Unit 4 Side |
AC Duct Erection/ |
200 DC System Commissioned and Load Tested/ |
Pre-Commissioning of Electrical Panels/ |
Erection of Brushgear Assembly/ |
Erection of Generator /Unit 3 |
252 MT Stator Assembly Lowering / |
252 MT Stator Assembly Lowering / |
252 MT Stator Assembly Lowering / |
Stator Unit 3 / in position |
Winding work/Stator Unit 4 |
Assembly of spring cushion of thrust surface of generator shaft/Unit 4 |
Unit 3/Top Bracket Arm Assembling |
Stator Unit 4/Toroidal Coil for Core Flux Test |
/ |
Unit 1 Boxed Up/ |
Stator 4 Core Building/ |
/ |
/ |
/ |
Machine Hall View Showing Unit 1 and Unit 2/ |
Stator Unit 3 and Unit 4, Rotor Unit 3/ at service bay |
Rotor unit 4/ at service bay |
Erection of Panels/in Progress |
Stator 3/Winding |
Bottom Shaft 3/Getting Ready for Erection |
Erection of Valve/ |
Transportation of BF Valve/(60MT) |
Erection of Penstock drain valve/ |
Header extension and pump erection/ |
U1 Marshalling Box cable termination/ |
U1 Inside turbine pit piping/ |
Unit 3 Rotor pole key fixing and locking/ |
Unit 1 - 4 machine floor/ |
Bottom bracket cleaning at service bay/ |
U2 Regulating lowered at pit for final assembly/ |
U2 TGB cooler pit inside piping/ |
U2 Turbine pit inside piping/ |
Power House fire fighting system suction pump/ |
U3 Stator Core Flux Test Done/ |
1 BF Valve Shifted to Valve house and unloaded at service bay/ |
1 BF Valve Shifted to Valve house and unloaded at service bay/ |
Unit 4/Rotor Rim Building |
Unit 1 and 2/Boxing Up Work |
Unit 3/Pole Mounting |
Unit 3/Erection of Bus Duct |
Erection of Guide Vanes/Unit 3 |
Bearing Box Up/Unit 1 |
Bus Duct Erection in/Unit 1 and 2 |
Power House/Tail Race |
Stator III/Core Building |
Power House/Tail Race |
Stator III/Core Building |
Unit 3 Turbine Final Assembly/Pivot Ring in Picture |
Unit 3 Rotor/Rim Building |
Unit 2 Box up/Top Bracket and Top Shaft Assembly |
Unit 2/Rotor Lowering to Unit Pit |
Unit 2/Stator Lowering to Unit Pit |
UNIT-I TO UNIT-IV MACHINE HALL PHOTO/ |
/ |
/ |
/ |
/ |
/ |